An experimental study of structure development during melt spinning of polethylend fiber
The development of crystallinity, orientation, and morphology during the melt spinning of linear polyethylene fiber was investigated. A moveable screw extruder spinning machine was constructed to facilitate examination of the spinning fiber from the spinneret to a point 175 cm down the spinline. The spinning machine was positioned over a rotating anode x-ray generator to allow direct x-ray diffraction studies on the moving filament. Filament diameter, temperature, and tension were also measured.
Eight sets of process conditions were examined by obtaining filament diameter, temperature, and wide angle x-ray diffraction patterns at numerous positions along the spinline. The x-ray patterns were analyzed by scanning microdensitometer and computer to obtain percent crystallinity and crystalline orientation functions. Analysis of experimental data produced values of filament velocity, velocity gradient, density, stress, and elongational viscosity as functions of distance from the spinneret. Crystallization rates and crystallization rate constants were calculated from x-ray crystallinity data. Density, birefringence, tensile properties, wide and small angle x-ray diffraction patterns, pole figures, and electron micrographs were obtained on final fibers.
Observed crystallization rates were several orders of magnitude higher than rates observed in quiescent melts at the same temperatures. Crystallization began at an initially high rate at a point near the maximum velocity gradient in the fiber and continued at decreasing rates further down the spinline. Crystallization rates increased with increasing takeup stress in spinning.
Orientation along the spinline was essentially the same as that observed in the final fiber at low and high takeup velocities. At intermediate velocities (l00 to 200 m/min) the orientation decreased down the spinline. This change was attributed to an increase in lamellar twisting as crystallization progressed.
Spinline stress was found to have an important role in crystallization kinetics and development of morphology in the spinning fiber. Final fiber properties correlated well with crystalline orientation as obtained by x-ray diffraction methods.
Thesis74b.D448.pdf
12.25 MB
Adobe PDF
8bc9de5a619fb631c74b8b9aa201242c