A study of trace metals found in sediment in a stream before and during strip mining of coal in the Cumberland Plateau of Eastern Tennessee
The drainage basin of Bill's Branch was disturbed by man only by a logging road and a powerline before strip mining for coal entered the basin. Samples were taken from the stream bed before stripping (set I, at the end of a dry summer season) and during stripping (set II, at the end of a wet spring season). This thesis deals with how these conditions affected the concentration(s), distribution(s), and mode(s) of occurrence of nine elements: Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn in the sediment.
The basin, located on the Fork Mountain 7-1/2' TVA Quadrangle, is in the New River watershed of the Cumberland Plateau of eastern Tennessee. The area is located in a physiographic province called the Wartburg basin where coal seams, shales, sandstones, and to a minor extent, discontinuous beds of siderite, are found in cyclothemic sequences.
Size separations were performed on sediment samples so that the >2mm, 2-1mm, and < 1mm sizes were obtained from five sampling sites. Petrographic studies were done on the >1mm sizes. The < 1mm sample was then separated into five sizes which were digested with acid. All of the < 1mm size fractions were analyzed by atomic absorption spectrophotometry. X-ray diffraction analyses were also done on these sized samples.
It was found from the acid digestion of the <lmm (bulk) samples that sediment from the sites affected by stripping may have increased in some metal concentrations due to an increase of hydrous Fe-Mn oxide accumulation. Metal concentrations in the sediment of a site below an eroded logging road did not appear to increase in metal concentrations which helps show the relatively minor significance of erosion due to increased runoff as a heavy metal source.
The metals that are easily exchanged from the sediment surfaces will be called "EDTA extractable." The term "entrapped" will be used for any material associated with these hydrous Fe-Mn oxides. Ethylenediaminetetraacetate (EDTA) and Na-dithionite extractions of < 1mm material showed that some metals, such as Cd, Co, Fe, and Ni, had approximately 15% of their total concentration as EDTA extractable metals, while 60% of their total concentration was found entrapped in the hydrous Fe-Mn oxides. Other metals, such as Cu, Mn, and Pb had entrapped metal concentrations that were also greater in amount (50% of total concentration) than EDTA extractable metal concentrations (20% of total concentration).
Size separations showed that at all sites, except for one further downstream, the percentage of 1000-105µ material decreased from set I (pre-stripping) to set II (during stripping), while the fine fractions increased. The reverse occurred at this one site due to increased rainfall. Apparently, the increased rainfall produced an increase in runoff and water discharge, which moved the coarser particles downstream to this site.
Acid dissolution of size separates showed that concentrations of Co, Ni, and Zn in the 1000-105μ, 105-53μ, and 53-5µ size fraction(s) may have increased when stripping commenced, while Cr, Cu, and Pb may have increased only in the 1000-105μ size fraction. The Mn concentration possibly increased with mining in the 1000-105μ and the 2-0.2u size fractions. The Cd and Fe concentrations possibly decreased with mining in the 1000-105µ size fraction and increased in the rest.
X-ray diffraction analyses showed that quartz was dominant in all the coarse size fractions, while illite and kaolinite were dominant in the finer size fractions. Montmorillonite, chlorite, and montmorillonitechlorite were found in the 5-2µ and 2-0.2µ size fractions. Goethite was found in the coarser sizes, while anglesite was found in minor amounts in the middle sizes. The Mn minerals showed scant appearances, but were most likely in amorphous forms. The type of minerals found did not change after the advent of strip mining.
Thesis75.U632.pdf
12.06 MB
Adobe PDF
f13d15941bac62bac1adb2d7fe27d696