The interaction of melt spinning, drawing, twisting, heat setting and untwisting on the crystalline morpholozy and mechanical properties of polyethylene fibers
The purpose of this investigation was to examine the effects of a series of sequential deformation and thermal treatments on the crystalline morphology and mechanical properties of melt spun high density polyethylene. The polymer studied was Phillips Marlex EMB 6050 with a melt index of 5.0. The treatments included twisting of spun filaments, drawing, twisting of drawn fibers, heat setting at 120°C, and untwisting of twisted and heat set fibers. At each treatment step the fiber structure was investigated by scanning electron microscopy, wide angle x-ray diffraction and small angle x-ray diffraction. The mechanical properties were characterized by performing tensile tests.
Drawing results in very high crystalline orientation, fibrillation and large increases in modulus and tensile strength. The natural draw ratio and total draw ratio for the spun filament depend on the orientation developed in the melt spinning process. At a draw ratio slightly greater than the natural draw ratio the amount of fibrillation depends on the spinning condition.
Twisting of either as-spun or drawn fibers decreased the axial orientation, modulus, tensile strength, and usually also the elongation to break of the fibers. The changes in these properties increased with twist angle. Twisting also caused a transformation of a small part of the polyethylene sample to the monoclinic crystal modification. Asspun filaments exhibit necking and yield point behavior. Twisting gradually removes the yield point and causes a more uniform elongation when the filaments are loaded in tension.
To a good first approximation, the change in orientation and modulus of drawn fibers with twist angle could be predicted using a model originally meant to describe the mechanics of yarns. It was assumed that the fibrils in the drawn and twisted fiber are analogous to the fibers of a twisted yarn.
Heat setting caused healing of voids generated during drawing and increased the perfection and periodicity of the stacking of lamellar crystals. Heat setting also caused the monoclinic polyethylene to transform back to the orthorhombic form, and it increased the modulus and tensile strength.
Untwisting returned the orientation in the fiber to essentially that which it would have if it had not been twisted. However, scanning electron microscopy examination showed that the fibrils were not simply returned to their untwisted form, but that they contained numerous kink bands.
Thesis75.S942.pdf
11.25 MB
Adobe PDF
def0284075e9cb80140646c0f6a7eebc