An experimental investigation of a radial face seal
An experimental method has been developed which will allow a complete description of the interface fluid film of a radial face seal. The equipment necessary for the monitoring of the vertical load, torque, temperature, supply pressure, interface pressure, interface clearance, and rotational speed has been integrated into a workable facility. The procedures needed for the operation of this equipment have been derived and are presented in this work.
The initial check-out of the facility has been completed for a particular design of a radial face seal. Tests have been conducted using Gulfspin 38 oil over a supply pressure range of 16.5 - 87 psig (1.14 x 105 - 6.0 x 105 N/m2), an interface clearance range of 2925 - 4146 µin. (74 - 105 μ), and at rotational speeds of 490 - 1030 rpm.
The experimental results have been compared with the values predicted by a numerical analysis program. The numerical analysis was based on variable fluid properties. . The experimental vertical loads were consistently below the predicted values with the differences decreasing at higher supply pressures. The interface pressures measured in the experiments reveal a trend toward pressure generation within the seal at higher supply pressures, lower interface clearances, and increased rotational speed. The experimentally determined temperatures were found to compare favorably with the predicted results. The torque values, obtained experimentally, did not compare favorably with the predicted results.
Thesis75.K523.pdf
3.3 MB
Adobe PDF
e8bcb4c81ea6148bf54da9438035c6ca