Neutronics Modeling of the Fort Saint Vrain High Temperature Gas-cooled Reactor for Comparison to Start-up Tests
Date Issued
August 2026
Author(s)
Estes-Lumpkin, Edan Kai
The University of Tennessee
Advisor(s)
Nicholas R. Brown
Additional Advisor(s)
Guillermo Maldonado
Xingang Zhao
Abstract
The Fort Saint Vrain initial core was modeled to compare neutronics results to those of Start-up Test A-3 and Start-up Test A-7. This was done to allow for comparison of a model against a prismatic HTGR that operated in the United States, for which there is a wealth of data available. This is an important step towards modeling the unique TRISO tests that were done in, or in support of, Fort Saint Vrain which could help support the licensing process of TRISO-fueled advanced reactors. Two different control rod orientation models were created and used to model both tests. Start-up Test A-3 investigated the multiplication factor of the entire core in 12 different subcritical configurations. The modeled results compared to multiplication factor values from Start-up Test A-3 showed that the six orientation and uniform orientation control rod models tended to overpredict keff [keff] by on average 2130 ± [+/-] 430 pcm and 2078 ± [+/-] 430 pcm, respectively. Investigations into different contributing factors found that running in external source mode produced a larger range in differences from experiment, 3315 ± [+/-] 1304 pcm, but could produce values that were within experimental uncertainty for 3 configurations. Start-up Test A-7 investigated the normalized axial flux profiles in different refueling regions of the core for 2 critical configurations. When compared to experiment, the total average differences in the regions for both models were between 5 and 7%. The average maximum differences from all regions compared to experiment were found to be between 18 and 25% for both models, with the six control rod orientation model performing slightly better. In almost all models and regions the maximum differences were found in regions of less importance close to the reflector. The axial flux profile differences in areas of less importance, the differences compared to keff values, and the 3 regions within experimental uncertainty produced using external source mode suggest that if further information is provided about the control rod orientations, this model may be able to generate inputs for further thermal-hydraulics or fuel performance modeling.
Degree
Master of Science
Major
Nuclear Engineering
Embargo Date
August 1, 2027