The design and analysis of a discrete wide band power operational amplifier
The purpose of this thesis is to design, analyze, implement, and evaluate experimentally a discrete operational amplifier that can operate as a feedback amplifier with negative voltage gains between one and ten. The rise time of this amplifier was less than 200 nanoseconds with currents of 200 milliamperes or greater into a fifty ohm load.
The thesis presents a brief introduction of operational amplifiers and their uses. A general approach to the design of an operational amplifier is discussed along with a detailed analysis of the bias, open-loop response, closedloop response, and noise of the amplifier. The calculated variation of the bias currents was less than 1% per degree centigrate between zero and fifty degrees. The calculated equivalent input noise voltage was 3.19 (10-9) volts/(Hz1/2). The transistors used in the input stage were FETs with input impedances greater than 109 ohms.
Experimentally the closed-loop rise times for negative gains of ten, five, and one were 167 nsec, 111 nsec, and 65.5 nsec respectively with currents of 200 mA or greater into a fifty ohm load. These rise times were measured after a square wave on the output was adjusted to have no overshoot. The measured differential linearity was less than ± 2.5%.
Thesis75.A758.pdf
4.53 MB
Adobe PDF
7b0e507806d2221a7e1ae246a087f89e