Stress-induced heating in A Nb-Ti superconducting composite
The use of superconducting magnets in experimental fusion reactors, motors and generators has attracted much attention in recent years. For a designated magnetic field and current density, it is important that the temperature of a superconducting magnet not rise above a certain critical value. If the temperature of a region in a magnet rises above this critical value, the resistance of the conductor will increase, leading to a normally conducting zone in that region. If the heat in this normal zone is not removed promptly, it could propagate, causing the whole magnet to quench. In a fusion reactor, the requirement of prompt heat removal becomes very critical due to the enormous amount of stored energy and extremely high cost of shut-down and repairs. Hence, the amount of heat generated in the superconducting materials by various mechanisms is of primary interest to magnet designers, particularly in the fusion community.
Different sources of mechanical heat generation were examined. In order to overcome the practical disadvantages of the solution to this nonlinear coupled thermoelasticity problem, a simple model was investigated. This model uses the hysteresis loop area, in the stress-strain curve of the superconductor, as the generated heat per unit volume of the material. To verify the model, in a series of tests the temperature change of a superconducting sample was measured under various loadings. The tests were carried out at room temperature and in liquid helium (4.2 °K). An existing two-dimensional finite element program was modified to calculate the total heat generation in an axisymmetric solid, due to electromagnetic and external loads. The program calculates the stresses and uses the loop area data to arrive at the generated heat.
Thesis76b.M629.pdf
6.91 MB
Adobe PDF
2eb078b56d942ab15617788ecb141c7c