Investigation of aerodynamic and acoustic similarity laws
Modelling is very useful in the design of fan/compressors; however, its satisfactory use requires a clear understanding of the physical principles involved in the relationship between model and prototype. Unless properly interpreted, the information obtained from models may be quite misleading. The criteria to be satisfied in order to relate the full-size machines to the results obtained in model tests are grouped under the general heading of similarity. The objectives of the present study were to investigate the acoustic similarity laws in detail and to determine the necessary acoustic scaling relationships between model and prototype for fan/compressors. Two methods commonly used for establishing similarity relationships, namely a dimensional analysis and an analysis of the characteristic equations of the system, were used.
The application of dimensional analysis to aerodynamic performance is a standard method in turbomachinery. Total pressure rise and volume flow rate are normalized by the characteristic length, rotor speed, and fluid density. A similar dimensional approach was used to establish the acoustic similarity laws. For any turbomachine, we are interested in the relationship of head or pressure, flow rate, power, torque, etc. in conjunction with size, speed, and the properties of the fluid. In the present study, the frequency of the radiated sound was introduced as one of important variables because by including the frequency of the radiated sound, the results are useful when the spectrum of the radiated sound is important. After judiciously selecting the twelve relevant
physical quantities (rotor size, volume flow rate, rotor speed, frequency of the radiated sound, fluid density, viscosity, sound speed, specific heat ratio, viscosity ratio, specific heat of gas at constant pressure, thermal conductivity, and acoustic power per frequency), these parameters were combined together into nondimensional forms with the aid of Buckingham's Pi Theorem.
The physical theory of sound waves deals with the systematic motion of a material medium relative to an equilibrium state and thus comprises the variational aspects of elasticity and fluid dynamics. Such perturbation of state can be described by incremental (or acoustic) variables, and approximate equations governing them can be obtained by artitrarily linearizing the general equations of motion. These results can be derived in an orderly way by invoking a perturbation analysis. The dependent variables appearing in the three fundamental equations, namely the continuity equation, the force equation, and the heat-exchange equation, were replaced by the sum of their equilibrium or zero-order values and their first-order variational components, and then the separate equations that must be satisfied by the variables of each order were formed. The first-order equations obtained are the usual starting points of the study of the acoustics. By expressing the first-order equations obtained in the respective nondimenstional forms, acoustic similarity conditions were considered.
The results of both the characteristic equation method and the dimensional analysis show that similarity based on the visco-thermal theory can be achieved by satisfying the six similarity conditions, that is the state relation similarity, geometric similarity, temporal similarity, acoustic similarity, dynamic similarity, and thermodynamic similarity. If these similarity conditions are satisfied, the effect of scaling on the sound power level may be represented by 20 log n (dB), where n is the scale factor which is defined by n=Lp/Lm, and where Lpand Lm are the rotor diameters of the prototype and model, respectively.
Thesis77.T838.pdf
4.8 MB
Adobe PDF
4e68a6cfa00d73d601e4ac08220f788d