Acoustic investigation of upper surface blown flaps
The acoustic characteristics of upper surface blown flaps were investigated experimentally. The blown flap was modeled by a slot nozzle exhausting over a plane flap and measurements were made in the free field and in a reverberation room. Flap length, flap deflection angle, nozzle aspect ratio and the jet exit Mach number were among the parameters that were varied. Shadowgraphic stills and movies were obtained for flow visualization and limited turbulence measurements were made using hot film anemometry. Flap surface pressure fluctuations were spectrum analyzed and cross-correlated with the far-field sound.
Measurements in the free and reverberant fields showed the sound output of a slot jet to be less than that of an equivalent area circular jet exhausting at the same mean velocity. In addition, the sideline plane of the slot jet was identified to be quieter than the flyover plane. For jet flaps the non-dimensional flap length (= flap length/ nozzle height) was shown to be the most important geometric parameter affecting the sound field. The sound output of jet flaps increases with increasing flap length, upto δF nearly equal to ten. With further increase in flap length the sound output decreases so that for all jet exit Mach numbers the sound output is maximum when δF ~ 10. This characteristic of the sound output of jet flaps brings out the importance of the location of the flap trailing edge relative to the termination of the jet potential core. Measured OASPL directivities, sound spectra and sound power data have been attributed to the combined effects of jet noise, edge noise, secondary mixing region noise, scrubbing noise and the shielding by the flap surface. Cross-correlations of the surface pressure fluctuations with the far-field sound showed the flap trailing edge to be a major noise source region, but the dominant noise mechanisms depend on the flap length.
At high jet exit Mach numbers flaps with δF around ten generate high intensity tones. Shadowgraphic pictures showed the presence of vortical structures in the secondary mixing region and a flapping motion of the jet potential core above the flap surface. This instability of the jet is thought to be triggered by the edge noise field of the flap which has maximum radiation in the upstream direction. The tone could be eliminated by modifications of the geometry that altered the flow structure in the primary mixing region or reduced the edge effect.
Thesis77b.J675.pdf
10.26 MB
Adobe PDF
f65e62d1dd69e8f394503a5817ce2668