Repository logo
Log In(current)
  1. Home
  2. Colleges & Schools
  3. Graduate School
  4. Masters Theses
  5. CT-114 Tutor: Evaluation of Glide Profiles
Details

CT-114 Tutor: Evaluation of Glide Profiles

Date Issued
May 1996
Author(s)
Ellis, Charles A.
Advisor(s)
R. D. Kimberlin
Additional Advisor(s)
Solies
F. Collins
Permanent URI
https://trace.tennessee.edu/handle/20.500.14382/60037
Abstract

The Aerospace Engineering Test Establishment was tasked to evaluate the CT-114 Tutor glide profile under various conditions including engine out and all combinations of landing gear and flaps extension. This thesis records the activities and results of that project [1].

Engine out glide performance was quantified for the clean gear up and clean gear down cases. Results of this first phase verified the current best glide speed of 130 KIAS for the clean gear up case. Accordingly, it was recommended that the current procedures and rules of thumb for clean gear up glide be retained. Flight testing with the landing gear extended determined that the best glide speed was significantly lower. During consultation with the CT-114 community, testing was directed to continue but only using 130 KIAS. Simulated engine out testing was completed to determine the engine RPM to be used to most accurately simulate engine out glide performance. Sixty-three percent RPM was recommended as most accurately simulating actual engine out conditions.

Phase two determined the effects upon glide performance of landing gear D Doors, flaps, external pylons, and external fuel tanks. Extension of the landing gear (D Doors closed) increased the flight path (descent) angle by 1.93° The D Doors alone increased the flight path angle by 0.43°. Half flaps increased descent angle by 1.62° and 3.24° for full flaps. External pylons had little effect (0.1°) while external pylons and fuel tanks caused a 0.47° increase in flight path angle.

Phase three utilized phase two data to develop the forced landing pattern. The same 360° turning pattern was used but the key altitudes were calculated using wings level (phase two) data extrapolated to account for the turning effects. It was determined that the current Aircraft Operating Instructions procedures and key altitudes were adequate for the clean configuration but were incorrect for all other cases. The requirements for accuracy and simplicity in estimating altitude requirements led to the recommendation that pilots increase the ideal high key altitude by 200 ft if in any configuration other than clean. Phase three culminated in four successful forced landings at 4 Wing Cold Lake.

 
Degree
Master of Science
Major
Aviation Systems
File(s)
Thumbnail Image
Name

Thesis96.E4.pdf

Size

7.55 MB

Format

Adobe PDF

Checksum (MD5)

15671755caee226c3d28d5745fdb2396


University Libraries

1015 Volunteer Boulevard
Knoxville, TN 37996
865-974-4351

Map & Directions
Donate to the Libraries
  • About
  • John C. Hodges Society
  • Speaking Volumes magazine
  • Outreach
  • Directory
  • Employment
  • Policies
  • Library Intranet
University of Tennessee power T logo

The University of Tennessee, Knoxville
Knoxville, Tennessee 37996
865-974-1000

Events
A-Z
Apply
Privacy
Map
Directory
Give to UT
Accessibility

Built with DSpace-CRIS software - Extension maintained and optimized by 4Science