Repository logo
Log In(current)
  1. Home
  2. Colleges & Schools
  3. Graduate School
  4. Masters Theses
  5. The melt spinning of nylon-66
Details

The melt spinning of nylon-66

Date Issued
March 1977
Author(s)
Danford, Merlin D.
Advisor(s)
James L. White
Additional Advisor(s)
Joe E. Spruiell
Edward S. Clark
Permanent URI
https://trace.tennessee.edu/handle/20.500.14382/59036
Abstract

The purpose of this study was to investigate the effect of spinline variables on the structure development and properties of nylon-66. Experiments were carried out using samples of nylon-66 polymer supplied by the Monsanto Company. The number average molecular weight of this polymer was determined to be 17,500.

The shear viscosity of nylon-66 melt was determined using an Instron Rheometer. The shear visocosity decreases with shear rate in the range of 200-1200 sec-1. The effect of moisture on the shear viscosity was determined by studying samples with moisture contents of 0.43 percent H2O and 0.01 percent H2O, and it was found that the viscosity decreases dramatically with increasing water content.

Melt-spun nylon-66 crystallizes into an alpha-triclinic structure, as determined from X-ray diffraction patterns of the spun fibers. There was no evidence for the beta-triclinic or gamma forms. The percent crystallinity was also determined, using a density gradient column, and was found to vary from about 36 percent to about 33 percent in going from low spinline stress to high spinline stress. Both crystalline and amorphous orientation factors were determined. It was found that the crystalline orientation factor fc increases with increasing spinline tension, and approaches a value of about 0.4 at the highest spinline tension. This value is lower than earlier results reported for polyethylene, polypropylene and nylon-6.

On-line birefringence studies indicate that crystallization occurs in the spinline, in contrast to the behavior of nylon-6, which does not crystallize in the spinline. Also, these measurements show that the crystallization process moves further down the spinline with increasing take-up velocity.

Mechanical properties of the melt spun fibers were studied. The tensile strength increased with increasing values of take-up velocity, birefringence, spinline stress, crystalline orientation factor, and amorphous orientation factor, while the elongation to break decreased with these variables.

 
Degree
Master of Science
Major
Chemical Engineering
File(s)
Thumbnail Image
Name

Thesis77.D253.pdf

Size

4.75 MB

Format

Adobe PDF

Checksum (MD5)

2187cd976b8ae317deb46d969f87960c


University Libraries

1015 Volunteer Boulevard
Knoxville, TN 37996
865-974-4351

Map & Directions
Donate to the Libraries
  • About
  • John C. Hodges Society
  • Speaking Volumes magazine
  • Outreach
  • Directory
  • Employment
  • Policies
  • Library Intranet
University of Tennessee power T logo

The University of Tennessee, Knoxville
Knoxville, Tennessee 37996
865-974-1000

Events
A-Z
Apply
Privacy
Map
Directory
Give to UT
Accessibility

Built with DSpace-CRIS software - Extension maintained and optimized by 4Science