Analysis of landslides and slope stability in coal surface mining
This investigation reviewed the literature pertaining to methods of slope stability analysis developed for civil engineering works. Particular emphasis was placed on those methods of analysis which are applicable to coal surface mine overburden waste fills typical of contour mining in the mountainous Appalachian region.
Using Bishop's Simplified Method of Slices and soil perameters determined by laboratory triaxial and direct shear strength tests, three existing landslides were analyzed to establish the reliability of the analysis procedure in predicting slope failures. After establishing the reliability of the analysis procedure, alternate cross sections were analyzed to evaluate surface mining fill bench regulations, and to determine the effects of various factors on stability of large overburden waste fills. The investigation determined that cross sections other than those specified by current Tennessee Surface Mine Regulations can result in higher factors of safety against sliding while possibly reducing coal production costs.
It was also determined that for large overburden waste fills two potential failure surfaces exist with nearly equal factors of safety. Those two failure surfaces correspond to: 1) the interface between the fill and foundation colluvium; and 2) the interface between the colluvium and intact rock. The controlling failure surface is determined by the relative strength between the waste fill material and the colluvium, and by the size of the fill. The colluvium-rock potential failure plane controlled for most large fills investigated. When the colluvium-rock failure plane controlled, the depth of the colluvium layer was an important factor in determining the stability of the fill. A deeper colluvium layer resulted in a less stable fill.
Thesis77.C682.pdf
5.82 MB
Adobe PDF
e1c20b7a0311ec23f1ffbe381a843653