The effect of ferrite level on the corrosion resistance of austenitic stainless steel weld metal
The purpose of this experimental study was to investigate the effect of initial ferrite content on the corrosion resistance of austenitic stainless steel weld metals after welding and aging at elevated temperatures. Various techniques such as optical metallography, X-ray diffraction of bulk extracted residues, and Magne Gage measurements of delta ferrite content were used to determine the precipitate identities, nucleation sites, morphology distribution, and kinetics of precipitation. Corrosion behavior was studied using anodic polarization curves. These were determined in a solution of 1N H2SO4 using a potentiostat. In order to selectively etch the specimen, a controlled potential etching test was run in a solution of 5% H2SO4 and 0.1 g/1 NH4SCN. The attacked surfaces of etched specimens were examined by optical microscopy and by scanning electron microscopy. Energy dispersive X-ray analysis was also applied to identify some of the etched particles.
It was found that the ferrite present in the as-deposited welds is replaced by the intermetallic sigma and chi phases during aging at elevated temperatures. Also the ferrite-austenite boundaries serve as easy nucleating sites for both carbides and the intermetallic phases, thus enhancing the rate of formation of such phases in welds containing ferrite as compared to materials of similar composition in which no ferrite exists.
Sensitization by carbide precipitation has a great effect on the anodic polarization curves for the high carbon grade welds. The passive current density increases at shorter aging times and then decreases after longer aging times. For the low carbon grade stainless steel welds the sensitization effect is not significant.
High ferrite content welds have both lower passive current densities and lower critical current densities than the low ferrite content welds have.
Chromium depletion in the grain boundaries itself is the cause of attack rather than the precipitates themselves. It is suggested that the distribution of chromium is a major cause of the intergranular corrosion in aged austenitic stainless steel weld metals.
From the etching test, it was found that a greater risk of intergranular attack occurred for the low ferrite content welds from the active region to the transpassive region. In high ferrite content welds the corrosive attack was uniformly distributed around the second phases, while in the low ferrite content welds attack was concentrated along the grain boundaries. It was also found that sigma phase can corrode rapidly beyond the transpassive region.
Thesis77.C449.pdf
13.42 MB
Adobe PDF
ea7eab9bf899ce2dbc4bf1688f18a9da