The effect of molecular weight parameters on the die swell of polymer melts
The effects of molecular parameters (molecular weight and its distribution) on the die swell properties of polystyrene were investigated under isothermal conditions. Four starting materials (two commercial samples and two samples of narrow molecular weight distribution) and blends of these materials were used.
The polystyrenes were rheologically characterized in steady shear measurements on a cone and plate rheometer and a capillary rheometer and in dynamic experiments using the Maxwell orthogonal (eccentric rotating) deformation mode.
The die swell was measured by photographing the extrudate emerging from the capillary die (L/D = 44) through a window in an environmental chamber attached to the lower part of the capillary rheometer. Simultaneously the steady shear rate and shear stress were recorded.
The die swell was correlated as a function of shear stress and was compared with predictions based on modified versions of Tanner's die swell theory. In order to use this theory one needed to know the normal stress-shear stress function and to make some assumption about the shear modulus G. In two cases studied, G was taken as an adjustable parameter or taken as a certain function of the shear stress. These predictions qualitatively explained the trends in the die swell data, but did not quantitatively correlate, notably in case of one extremely broad molecular weight distribution material. Tanner made an allowance for the low shear stress asymptote by introducting a die swell correction term of O.1. In the present work this term was found to depend on molecular weight distribution and several empirical correlations were suggested for correlating it.
The form of the normal stress-shear stress function has an important effect on the prediction of Tanner's theory. This function was studied both experimentally and theoretically. In the experimental studies this function was found to decrease in magnitude with broadening molecular weight distribution. Using a quadratic blending law model suggested by BMEO (Bogue, Masuda, Einaga and Onogi) it was possible to show reasonable agreement with the trends of the slopes of the curves, although the absolute placement of the curves varies with certain adjustable parameters in the model.
Thesis78.R325.pdf
4.95 MB
Adobe PDF
e8c7880003897afbd4ecc6e88a188b8a