Repository logo
Log In(current)
  1. Home
  2. Colleges & Schools
  3. Tickle College of Engineering
  4. Engineering -- Faculty Publications and Other Works
  5. Faculty Publications and Other Works - Civil & Environmental Engineering
  6. Typical types and formation mechanisms of haze in an eastern Asia megacity, Shanghai
Details

Typical types and formation mechanisms of haze in an eastern Asia megacity, Shanghai

Date Issued
January 1, 2012
Author(s)
Huang, K
Zhuang, G
Fu, Joshua S
Wang, Q
Liu, T
Zhang, R
Jiang, Y  
Deng, C
Fu, Q
Hsu, N C
Cao, B  
Permanent URI
https://trace.tennessee.edu/handle/20.500.14382/16240
Abstract

An intensive aerosol and gases campaign was performed at Shanghai in the Yangtze River Delta region over Eastern China from late March to early June 2009. This study provided a complementary picture of typical haze types and the formation mechanisms in megacities over China by using a synergy of ground-based monitoring, satellite and lidar observations. During the whole study period, several extreme low visibility periods were observed with distinct characteristics, and three typical haze types were identified, i.e. secondary inorganic pollution, dust, and biomass burning. Sulfate, nitrate and ammonium accounted for a major part of PM2.5 mass during the secondary inorganic pollution, and the good correlation between SO2/NOx/CO and PM2.5 indicated that coal burning and vehicle emission were the major sources. Large-scale regions with high AOD (aerosol optical depths) and low Ångström exponent were detected by remote-sensing observation during the dust pollution episode, and this episode corresponded to coarse particles rich in mineral components such as Al and Ca contributing 76.8% to TSP. The relatively low Ca/Al ratio of 0.75 along with the air mass backward trajectory analysis suggested the dust source was from Gobi Desert. Typical tracers for biomass burning from satellite observation (column CO and HCHO) and from ground measurement (CO, particulate K+, OC, and EC) were greatly enhanced during the biomass burning pollution episode. The exclusive linear correlation between CO and PM2.5 corroborated that organic aerosol dominated aerosol chemistry during biomass burning, and the high concentration and enrichment degree of arsenic (As) could be also partly derived from biomass burning. Aerosol optical profile observed by lidar demonstrated that aerosol was mainly constrained below the boundary layer and comprised of spheric aerosol (depolarization ratio <5%) during the secondary inorganic and biomass burning episodes, while thick dust layer distributed at altitudes from near surface to 1.4 km (average depolarization ratio = 0.122 ± 0.023) with dust accounting for 44–55% of the total aerosol extinction coefficient during the dust episode. This study portrayed a good picture of the typical haze types and proposed that identification of the complicated emission sources is important for the air quality improvement in megacities in China.


doi:10.5194/acp-12-105-2012

Disciplines
Civil and Environmental Engineering
Comments

This article has been funded by the University of Tennessee's Open Publishing Support Fund.

Recommended Citation
Atmos. Chem. Phys., 12, 105-124, 2012 www.atmos-chem-phys.net/12/105/2012/ doi:10.5194/acp-12-105-2012
Embargo Date
January 2, 2014
File(s)
Thumbnail Image
Name

Fu_TypicalTypes.pdf

Size

5.31 MB

Format

Adobe PDF

Checksum (MD5)

6472e95bb85650c2e99ae4ac2b716e0a

Built with DSpace-CRIS software - Extension maintained and optimized by 4Science

  • Privacy policy
  • End User Agreement
  • Send Feedback
  • Contact
  • Libraries at University of Tennessee, Knoxville
Repository logo COAR Notify